![]() Note: The commands may vary depending on the exact model of your switch. Note: To learn how to access an SMB switch CLI through SSH or Telnet, click here. New username or password, enter the credentials instead. The default username and password is cisco/cisco. ![]() If the delay timer is expired, the state of the tracking object is changed to X and the X stateĬonfigure IP SLA Tracking for IPv4 Static Routes Configure ICMP Echo Operations.If during the time that the timer is set, the original state (Y) is received again, the timer is.The state of the tracking object is not changed and the tracking object starts the delay timer.To X from Y, the tracking object performs the following actions: Delay - When the result of an IP SLA operation indicates that the state of the tracking.Tracker - Tracks the results of operations.Configured Source IP address or Source interface is not accessible - Return code is set to.No any ICMP reply has been received - Return code is set to error.ICMP Error reply has been received - Return code is set to error.ICMP Echo reply has been received - Return code is set to OK.Return Code - After an operation has been finished, the operation return code is set.Timeout value - Specifies the interval time of waiting for the ICMP echo reply message or.Which means it has been created but not activated. SLA Operation State - This can be either Scheduled, which means the operation begins.An application that is bound to a non-existing tracking object will receive the Up Note: If the IP SLAs operation specified by the track argument is not configured or is its schedule is Operation return code to the object state: The following table specifies the conversion of the IP SLAs The state is either UpĪfter object creation, the state is set to Up. Object State - Each tracking object maintains an operation state.Operation - Each IP SLAs ICMP Echo operation sends a single ICMP Echo request to a targetĬonfigured frequency rate.The following describes the main terms used in this article: Is Up, the static route state remains Up. If the track status is down, the static route state is set to Down. The track operation isĪssigned to a static route. The status to Up or Down, based on the success or failure of the ICMP destination. A track object is used to track operation results and set Monitors success or failure of replies from the host. Internet Control Message Protocol (ICMP) packets to the address defined by the user (a host on the requiredĭestination network), and also defines the next hop to use for the ping operation. Routes also relies on IP SLAs operations to detect connectivity to destination networks. Similar to IP SLAs tracking for Virtual Router Redundancy Protocol (VRRP), IP SLAs object tracking for static Is in state Up) can be selected for routing traffic. If connectivity to theĭestination network is lost, the route state is set to Down, and if available, a different static route (which Protocol Service Level Agreement (IP SLA) Object tracking for static routes provides a mechanism to track theĬonnectivity to the destination network via the next hop specified in the static route. ![]() Static route although it does not actually provide connectivity to the destination network. Metric to the destination network and the status of the outgoing interface to the next hop is Up, however theĬonnectivity is broken somewhere along the path to the destination network. For example, if the static route in question has the lowest Network is not reachable via the specified next hop. When using static routing, you may experience a situation where a static route is active, but the destination Note: To learn how to configure an IPv4 static route on your switch, click here.įor instructions on how to configure IP SLA tracking for IPv4 static routes through the web-based utility, click In this scenario, the static route has been preconfigured. This article provides instructions on how to configure the IP SLA tracking settings for IPv4 static routes on
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |